HP EVA Array iSCSI Connectivity Option - Manual (Page 211)

k. Select the CHAP Login Information check box.
l. Enter the CHAP secret for the mpx100/100b discovered iSCSI Initiator in the Target Secret
box. For example:
CHAPsecret01
m. Select the Mutual Authentication check box.
n. Click OK.
o. Click OK and the initiator completes normal login.
Enabling bidirectional CHAP during discovery and
bidirectional CHAP during normal session
Table 37 lists the parameters you need to enable bi–directional CHAP during discovery and bidirectional
CHAP during normal session.
Table 37 CHAP bidirectional and bidirectional settings
mpx100/100b secret settings MS Initiator secret settings
iSCSI Port hpstorageworks General Tab Secret Hpstorageworks
Discovered iSCSI
Initiator
CHAPsecret01 Add Target Portal CHAPsecret01
iSCSI Presented Target hpstorageworks Log on to Target CHAPsecret01
NOTE:
These are examples of secret settings. You must configure CHAP with settings that apply to your
specific network environment.
1. Enable CHAP for the mpx100/100b Discovered iSCSI Initiator entry. Select one of the following
procedures, depending upon the interface you are using:
a. To enable CHAP for the mpx100/100b Discovered iSCSI Initiator entry using HP
StorageWorks mpx Manager:
• If the iSCSI Initiator is not listed under Discovered iSCSI Initiators:
i. Go to the Wizard menu and select the Add Initiator Wizard and enter the iqn
name.
ii. Select the Enable CHAP check box.
iii. Enter a CHAP secret. For example:
CHAPsecret01
• If the iSCSI Initiator is already listed under Discovered iSCSI Initiators:
i. Select the Initiator in the left-hand column of the Discovered ISCSI Initiator list.
ii. Click the Information tab.
iii. Select the Enable CHAP check box.
iv. Enter a CHAP secret. For example:
CHAPsecret01
b. To enable CHAP for the mpx100/100b Discovered iSCSI Initiator entry using the
mpx100/100b CLI:
• If the iSCSI Initiator is not listed under the Show Initiators command:
i. Enter the initiator add command and add the iSCSI Initiator that is about to
do discovery.
ii. Enable CHAP and enter a CHAP secret. For example:
CHAPsecret01
• If the iSCSI Initiator is already listed under the Show Initiators command:
i. Enter the initiator mod command and select the iSCSI Initiator that is about to
do discovery.
EVA iSCSI connectivity user guide 211