HP Color LaserJet 9500 Multifunction Printer series User Manual
Page 198
182 Chapter 7 – Selecting and using media
Rev. 1.0
Toner blisters
Toner is not adhering correctly to the media.
•
Make sure that the correct type is set (see “Determining media type” on
page 171).
•
Use media that the MFP supports (see “Supported types of media” on page 164).
•
Make sure that the media type uses the proper print mode.
Toner on the back of the page
This can occur under these conditions:
•
Prepunched paper is being used, and the toner has leaked through the holes.
Make sure that the toner coverage on the page does not overlap the prepunched
holes.
•
An incorrect custom size is set for the media. Measure the media and set the size
at the control panel (see “Setting media size and type” on page 161).
•
After a jam, toner from the jammed media might have remained in the MFP. Print a
few more pages in order to remove the excess toner.
Media-related copy- and print-quality issues
Issue
Recommended action