HP Color LaserJet 9500 Multifunction Printer series User Manual
Page 35
ENWW
Loading input trays 19
1
1
6
Adjust the front (X) media guide by pressing tab on the guide and slide the
guide until it gently touches the paper.
7
Set the Custom/Standard switch to Custom.
8
Slide the tray into the MFP.
9
Look at the control panel within a few seconds of closing the tray. (Open
and close the tray if the time has already elapsed.) The control panel
displays the tray size and type configuration. Do one of the following:
•
If the size and type settings are correct, touch
E
XIT
to accept the settings.
•
If the size and type settings are not correct, touch
O
K
. The
TRAY N
SIZE=*<SIZE>
menu is displayed.
10
To change the size setting, touch the correct paper size. The message
SETTING SAVED
is displayed for a moment, and then the tray type menu is
displayed.
Note
Depending on the size that you selected, the MFP might prompt you to
move the Custom/Standard switch in the tray to another position. The MFP
might also prompt you to move the paper guides. Follow the instructions on
the control panel, close the tray, and then repeat this procedure starting
with step 9.
6
7
8