HP XP P9500 Storage - Manual (Page 178)

Table 52 How to Prepare the Configuration Files at Each Site (3DC Multi-Target (Cnt Ac-S Z x Cnt
Ac-J Z) configuration) (continued)
How to Prepare Contents File Type
At the Secondary Site At the Local Site At the Primary Site
Not required Not required Define a path set Path set definition file •
An inter-control unit
logical path from
the primary site to
the local site
•
An inter-disk
controller logical
path from the
primary site to the
remote site
Not required Define a path set Not required An inter-control unit
logical path from the
local site to the
primary site
Define a path set Not required Not required An inter-disk controller
logical path from the
remote site to the
primary site
Not required Not required Define a route list Route list definition
file/Command
device definition file •
A route/command
device from the
primary site to the
local site
• A route/command
device from the
primary site to the
remote site
Not required Define a route list Not required A route/command
device of Local
→
Primary
→ Remote
Define a route list Not required Not required A route/command
device of Remote
→
Local → Primary
Transfer from the
primary site Transfer from the
primary site Define a copy group A Continuous Access
Synchronous Z copy
group Copy group
definition file
Define a copy group A Continuous Access
Journal Z copy group
NOTE: If you define the route list, the route list definition file and the command device definition
file will be created at the same time.
Definition Procedure (3DC Multi-Target (Cnt Ac-S Z x Cnt Ac-J Z) Configuration)
First, set the items that need to be set by using Remote Web Console from among the items listed
in
Table 49 (page 175) .
This section explains the definition of a 3DC Multi-Target (Cnt Ac-S Z x Cnt Ac-J Z) configuration
as shown in the ISPF panel.
The following explains the legend for the figures used for the operation procedures described in
this section:
178 Configuration definitions