HP XP P9500 Storage - Manual (Page 202)

Table 62 How to Prepare the Configuration Files at Each Site (Delta Resync Configuration) (continued)
How to Prepare Contents File Type
At the Secondary Site At the Local Site At the Primary Site
definition file primary site primary site group
Define a copy group A Cnt Ac-J copy group
Define a copy group A Cnt Ac-J copy group
for Delta Resync
NOTE: If you define the route list, the route list definition file and the command device definition
file will be created at the same time.
Definition Procedure (Delta Resync Configuration)
First, set the items that need to be set by using Remote Web Console from among the items listed
in
Table 59 (page 198) (excluding a Delta Resync control path).
This subsection explains the definition procedure in Business Continuity Manager. A delta resync
configuration is defined in the following procedure.
1.
Create a disk configuration definition file.
Create a disk configuration definition file by performing a Local Scan at each site, and then
transfer the file to the other sites.
2. Perform setup at the primary site.
At the primary site, create the necessary path set definition file and route list definition file,
establish a logical path, and register a command device.
3. Perform setup at the local site.
At the local site, create the necessary path set definition file and route list definition file,
establish a logical path, and register a command device.
4. Specify settings at the remote site.
At the remote site, create the necessary path set definition file and route list definition file,
establish a logical path, and register a command device.
5. Create copy groups.
At the primary site, define copy groups and make copy pairs.
For details on each definition procedure in this section, see the following:
•
Procedure for a local scan
For details, see “Performing a local scan to acquire volume information” (page 124) . For details
on how to operate the ISPF panels, see “Local scan procedure” (page 588) .
•
Procedure for defining a path set and for establish a logical path
For details, see “Establishing a logical path” (page 126) . For details on how to operate the
ISPF panels, see “Creating a path set” (page 595) and “Establishing a logical path” (page 610) .
•
Procedure for defining a route list
For details, see “Defining a route list” (page 611) . For details on how to operate the ISPF panels,
see “Local scan procedure” (page 588) .
202 Configuration definitions