HP XP P9500 Storage - Manual (Page 742)

Causes of errors that might occur while creating or updating a configuration file and the
recommended actions
Table 133 (page 742) describes the causes of errors that might occur while creating or updating a
configuration file from the ISPF panel, and includes the recommended actions:
Table 133 Causes and recommended actions for an error that might occur while creating or updating
a configuration file (for the ISPF panel)
Recommended Action Cause Output Message No.
There is not enough free capacity on the device
or VTOC. Check the required device capacity An attempt to allocate the
configuration file failed. YKS086E ,
YKS270E
1
and allocate a sufficient amount of free
capacity.
(ALLOCATION FAILED is
output in the YKS086E
message.)
The configuration file to be used is being used
by another user. Make sure that the user is a
valid user. The configuration file is
being used.
(UNAVAILABLE DATASET
is output in the YKS086E
message.)
2
The YKS086E message displays the dataset
format that causes the error and the correct The configuration file
dataset format is invalid.
(DSORG, RECFM, LRECL, or
BLKSIZE
is output in the
YKS086E message.)
3
dataset format. Delete the configuration file in
which the error has occurred, check the dataset
format and the required device capacity, and
then reallocate a configuration file.
One of the possible causes is an extent
allocation failure. Depending on the An error occurred while
editing the configuration file YKS085E and
YKS270E
4
configuration, the correct allocation might not by using the EXECIO
TSO/E REXX
command. be possible when allocation using a
configuration file is performed, because the
system default values are used for the amount
of capacity for primary allocation and
secondary allocation. In this case, take either
of the following actions:
• Delete the configuration file in which an
error occurred, check the dataset format and
the required device capacity, and then
reallocate a configuration file.
•
Use CLIST ICQSPC00 to increase free
capacity in the configuration file. For details
on CLIST ICQSPC00, see the TSO/E
Customization.
The length of the configuration file name
exceeds 44 characters. The name of a configuration
file is too long. YKS285E 5
Stop creating the configuration file, and then
re-create it so that the file name is no more than
44 characters.
NOTE: For details about the dataset format and device requirements for a configuration file,
see the HP XP P9000 for Business Continuity Manager Software Reference Guide.
What to do when an error occurs while creating a configuration file (for YKBTSCAN)
The following tables describe the causes of errors that might occur while creating or updating a
configuration file by using the YKBTSCAN, and the recommended actions.
742 Troubleshooting