HP StorageWorks XP Remote Web Console Software - Manual (Page 168)

1. Ensure that the Remote Web Console main window is in Modify mode.
For detailed information about how to do this, see the HP StorageWorks XP24000/XP20000
Remote Web Console User Guide.
2. Ensure that the Journal Operation window is open (see “Journal Operation Window”
(page 116) ).
3. Do one of the following:
•
In the tree, right-click a journal group under Registered, and then select JNL Groups and
Change JNL Option.
•
In the upper-right list, right-click the desired journal group, and then select JNL Groups
and Change JNL Option.
CAUTION:
•
You can select Change JNL Option only when one of the following conditions is satisfied:
◦ The attribute of the journal group is Initial.
◦ The status of the journal group is Active.
◦ The status of the journal group is Stop.
◦ The status of the journal group is Hold.
◦ The status of the journal group is Holding.
•
When one journal group uses multiple mirror IDs, whether you can select depends on
the status of the journal group whose mirror is not in Hold, Holding, or Hold(Failure) status.
•
If the status of the journal group is Active, or if the status of the master journal group is
Hold or Holding, you can change only the Line of Speed option.
4. In the Change JNL Option window ( “Change JNL Option Window” (page 169) ), change journal
group options and then click Set.
CAUTION: If the status of the journal group is Active, or if the status of the master journal
group is Hold or Holding you can change only the Line of Speed option.
If you have selected two or more journal groups in step 3 , and want to make some options
in the Change JNL Options window unchanged, then specify blank for the options. If you
specify blank for an option, the option value remains unchanged. If you specify a value other
than blank, the specified value is set to the selected journal groups.
5. See the Preview list in the Journal Operation window to check the settings that you have made.
•
To modify a setting, select and right-click the setting in the Preview list, and then select
Modify.
•
To cancel a setting, select and right-click the setting, and then select Cancel.
6. Click Apply to apply the settings. If an error occurs, the error code appears in the right column
of the Preview list. To view detailed information about the error, right-click the error code and
select Error Detail.
168 Using Journal Groups