Kenwood TM-D710GE - Manual (Page 73)

69
EchoLink 07
Your link station callsign will be displayed at the top of the screen in the Title bar and stations connected to EchoLink are
shown. The software will already be connected as a link station. Next, select “Sysop Settings” from the Tools pulldown
menu and open the Sysop Setup window. Click the RX Ctrl tab.
Fig. 7-37 Sysop Setup Window: RX Ctrl Tab
Select the “Serial CTS” radio button in the Carrier Detect frame. Configure the “Serial Port” dropdown list for the port
used for EchoLink. Confirm the correct serial port to use by examining your computer configuration; the correct port
depends on your particular computer.
If MCP‑2A/6A is installed, usually this software uses the same port as EchoLink software. When there is only one COM
port on a computer, it is usually COM1. If a USB‑serial conversion cable is being used, the correct COM port number
may be COM2 or larger.
Do not check the Invert Sense check box for the TM‑D710 and TM‑V71 transceivers. This is to set the Output Logic
of Squelch Control from the transceiver to “Active High”. Refer to Step 3 of Parameter Settings in Using MCP‑2A/6A to
Configure the TM-D710A/E/GA/GE (TM-V71A/E) (page 74) . It is not necessary to check the Squelch Crash Anti-
Trip check box either. Next, click the TX Ctrl tab.
Fig. 7-38 Sysop Setup Window: TX Ctrl Tab