Kenwood TM-D710GE - Manual (Page 91)

87
MCP-2A/6A Memory Control Program 08
Fig. 8-9 MCP‑6A Splash Window
5 Select the communication port.
Specify in the COM Port frame the communication port (COM Port) that will be used to communicate via your computer
with the target station. You cannot select grayed out ports. If all ports are grayed out, this indicates your computer has no
COM ports installed and you will not be able to use the MCP‑6A software even if you click the “OK” button.
Fig. 8-10 MCP‑6A COM Port Setting Window
6 Read the information of TM‑D710GA/GE.
• Read the desired information of TM‑D710GA/GE that you wish to edit.
• Click the “OK” button. Next, select “Read Data from the Transceiver” from the Program pulldown menu and read the
information from the target transceiver.
Note:
◆ The basic method of using MCP-6A is to read the existing transceiver data into MCP-6A, edit the configuration, and then
write the new configuration back to the transceiver.