Kenwood TM-D710GE - Manual (Page 82)

78
08 MCP-2A/6A Memory Control Program
6 Finish the installation. The fact that information is read from the target transceiver completes the MCP‑2A installation.
Click the “OK” button, select “Read Data from the Transceiver” from the Program pulldown menu and read the information
from the target transceiver.
Note:
◆ The basic method of using MCP-2A is to read the existing transceiver data into MCP-2A, edit the configuration, and then
write the new configuration back to the transceiver.
Fig. 8-5 MCP‑2A Read Transceiver Advisory Message
Fig. 8-6 MCP‑2A Program Menu: Read Data from the Transceiver