Kenwood TM-D710GE - Manual (Page 78)

74
07 EchoLink
Using MCP-2A/6A to Configure the TM-D710A/E/GA/GE (TM-V71A/E)
1 Select “Menu” > “Aux” (MCP‑2A) or “Menu” > “Radio” > “AUX” (MCP‑6A) from the Edit pulldown menu. Confirm
“1200” bps is configured for “Data Speed [bps]”.
• Data Speed can also be confirmed using Menu 518 (TM-D710A/E, TM-V71A/E) or Menu 919 (TM-D710GA/GE).
2 Configure “SQC Output Source” for “SQL” in the dropdown list. This is the same as Menu 520 (TM-D710A/E,
TM‑V71A/E) or Menu 921 (TM‑D710GA/GE).
Fig. 7-44 MCP‑2A Aux Window: Data Speed and SQC Output Source
3 Select “Menu” > “Transmit/Receive” (MCP‑2A) or Menu” > “Radio” > “Transmit/Receive” (MCP‑6A) from the Edit
pulldown menu. When using CTCSS or DCS for the purpose of preventing extraneous signals or noise from being
fed into the Internet from a link station, configure “EchoLink RX Monitor” for “Busy Only” in the dropdown list. When
EchoLink Sysop mode is used, all signals received on the data band are output from the speaker regardless whether
CTCSS or DCS has matched; whereas, only those signals that match CTCSS or DCS are output from the data terminal.
Fig. 7-45 MCP‑2A Transmit/Receive Window: EchoLink RX Monitor
4 Select “Data Terminal” (MCP‑2A) or “Radio” > “Date Terminal” (MCP‑6A) from the Edit pulldown menu. Configure
“SQC Output Logic” for “High” in the dropdown list so that a false Busy state is never detected, even when the
transceiver is turned OFF.
Fig. 7-46 MCP‑2A Data Terminal Window: SQC Output Logic