Kenwood TM-D710GE - Manual (Page 75)

71
EchoLink 07
Check the While Active checkbox and configure the ID interval for sending the ID. If the Wait for clear frequency
checkbox is checked, the ID will only be transmitted after the frequency becomes clear. Next, click the Options tab.
Fig. 7-41 Sysop Setup Window: Options Tab
The initial settings are fine to use. No changes are necessary. Finally, click the RF Info tab.
Fig. 7-42 Sysop Setup Window: RF Info Tab
At this point, you must enter your link station information. While initially experimenting and setting up your station,
it’s best not to enter this information. This information is sent to the EchoLink server. After you disconnect from the
EchoLink server, this information will continue to be public via the server for some time. Heed this warning!