Goulds Pumps CV 3196 i-FRAME - IOM - Manual (Page 81)

5. Remove the clamp-ring screws (236A) and separate the clamp ring (253B) from the bearing housing
(134).
You must remove the bearings before you can remove the clamp ring from the shaft.
112A
236A
253B
423
370D
134
6. Remove the bearing housing (134) and the bearings (112A and 168A) from the shaft (122).
253B
168A
112A
496
134
7. Remove the bearing housing O-ring (496) and the inboard bearing (168A).
122
168A
248A
112A
136
382
253B
8. Remove the bearing locknut (136) and the bearing lockwasher (382).
9. Remove the outboard bearings (112A) and the clamp ring (253B).
NOTICE: Do not remove the oil flinger unless it is damaged. Doing so may result in unnecessary
shutdown time or equipment damage.
NOTICE: Use force only on the inner race when you press bearings off the shaft. Do not use force
in situations in which you might break a part. Doing so may result in equipment damage.
NOTICE:
Save the bearings for inspection. Do not reuse the bearings. Doing so may result in decreased
performance.
10. Remove the outboard labyrinth oil seal (332A) from the bearing housing (134).
Maintenance
Model CV 3196 i-FRAME Installation, Operation, and Maintenance Manual 79