Goulds Pumps CV 3196 i-FRAME - IOM - Manual (Page 99)

a) Coat the outside of the bearing housing (134) with oil.
b) Coat all the internal surfaces of the bearing frame (228) with oil.
c) Install the shaft assembly into the bearing frame (228).
Make sure that the shaft rotates freely.
d) Install the clamp bolts (370C) in the bearing housing (134) and tighten by hand.
e) Install the jack bolts (370D) with the locknuts (423) in the bearing housing (134) and tighten by
hand.
Assemble the rotating element and the bearing frame ( LTi )
CAUTION:
Wear insulated gloves when you use a bearing heater. Bearings get hot and can cause physical injury.
NOTICE: Make sure that the pipe threads are clean, and that you apply thread sealant to the plugs and
fittings. Failure to do so may result in equipment damage or decreased performance.
NOTICE: Use an induction heater that heats as well as demagnetizes the bearings when you install
bearings. Failure to do so may result in decreased performance.
1. Prepare the bearing frame (228) as follows (see the illustration):
a) Install the oil-fill plug (113A).
b) Install the oil-drain plug (408A).
c) Install the sight glass (319).
d) Install the sight oiler plug (408J).
e) Install the plug for the oil-cooler inlet (408L).
f) Install the plug for the oil-cooler outlet (408M).
g) Install four oil-mist connection plugs (408H).
Or: Install two grease fittings (193) and two grease-relief plugs (113).
h) Attach the bearing-frame foot (241) and fasten the bolts (370F) by hand.
370F
241
408A
408L
319
228A
408W
113A
372T 761B
408W
408M
408N
2. Install the oil flinger (248A) onto the shaft (122).
NOTICE: The oil flinger is press fitted onto the shaft. Use a properly sized driver. Failure to do so
may result in damage to the oil flinger.
3. Place the bearing-clamp ring (253B) onto the shaft (122).
Maintenance
Model CV 3196 i-FRAME Installation, Operation, and Maintenance Manual 97