Goulds Pumps CV 3196 i-FRAME - IOM - Manual (Page 84)

228A
241
370F
370D
423
134
370C
2. Remove the clamp screws (370C) and back off the jam nuts (423).
3. Tighten the jack screws (370D) evenly to move the bearing housing (134) out of the bearing frame
(228A).
4. Remove the shaft assembly from the bearing frame (228A).
5. Remove the jack screws (370D) and the nuts (423).
6. Remove the bearing housing O-ring (496) and the inboard bearing (168A).
122
168A
248A
112A
136
382
253B
7. Remove the bolts (371C), the end cover (109A), and the gasket (360C).
8. If necessary, remove the outboard labyrinth oil seal (332A) from the end cover (109A) and remove the
O-rings (497F and 497G).
Labyrinth oil-seal O-rings are part of the 3196 maintenance kits, or they are sold separately.
109A
332A
371C
360C
9. Remove the bearing housing (134) and bearings (112A) from the shaft (122) .
Maintenance
82 Model CV 3196 i-FRAME Installation, Operation, and Maintenance Manual