Goulds Pumps CV 3196 i-FRAME - IOM - Manual (Page 83)

9. Remove the O-rings (497F and 497G) if it is necessary.
Labyrinth oil-seal O-rings are part of the 3196 maintenance kits, and they are sold separately.
109A
332A
371C
360C
10. Remove the bearing housing (134) and the bearing (112A) from the shaft (122).
134
122
112A
11. Remove the bearing locknut (136), the bearing lockwasher (382), and the outboard bearing (112A).
NOTICE: Use force only on the inner race when you press bearings off the shaft. Do not use force
in situations in which you might break a part. Doing so may result in equipment damage.
NOTICE:
Save the bearings for inspection. Do not reuse the bearings. Doing so may result in decreased
performance.
122
136
112A
382
Disassemble the power end ( XLT-i and i17 with duplex bearings)
1. Remove the bearing frame to frame foot (241) using the frame-foot bolts (370F).
Maintenance
Model CV 3196 i-FRAME Installation, Operation, and Maintenance Manual 81