MSI X2-109 v1 - Manual (Page 121)

Embedded MegaRAID Software User’s Guide A-1
Version 2.0 Copyright © 2006 by LSI Logic Corporation. All rights reserved.
Appendix A
Events and Messages
This appendix lists the MegaRAID Storage Manager software events that
may appear in the event log.
MegaRAID Storage Manager software monitors the activity and
performance of all controllers in the workstation and the devices attached
to them. When an event occurs, such as the start of an initialization, an
event message appears in the log at the bottom of the MegaRAID
Storage Manager window.
Note: MegaRAID Storage Manager software can be used to
manage a wide range of MegaRAID controllers. Some of
the events and messages listed in this appendix are not
applicable to Embedded MegaRAID Software
.
Each message that appears in the event log has an error level that
indicates the severity of the event, as shown in
Table A.1 .
Table A.2 lists all of the MegaRAID Storage Manager software event
messages. The event message descriptions include placeholders for
specific values that are determined when the event is generated. Some
of the error messages are relevant only for hardware RAID.
Table A.1 Event Error Levels
Error Level Meaning
Information Informational message; no user action is necessary.
Warning Some component may be close to a failure point.
Caution A component has failed, but the system has not lost data.
Fatal A component has failed, and data loss has occurred or will
occur.
Dead A catastrophic error has occurred, and the controller has died.
This event is seen only after the controller has been restarted.