MSI X2-109 v1 - Manual (Page 80)

5-6 MegaRAID Storage Manager Software Overview and Installation
Version 2.0 Copyright © 2006 by LSI Logic Corporation. All rights reserved.
first edit the startupui.bat file. Specifically, you must add the IP
address of the remote server to the end of the startupui.bat file.
For example, to connect to a remote framework on server 192.168.0.10,
add the IP address to the end of startupui.bat as shown in this
example:
start JRE\bin\javaw -classpath .;GUI.jar GUI.VivaldiStartupDialog
ajsgyqkj=71244 192.168.0.10
Be sure to include a space in front of the IP address, as shown in the
example.
5.3.2 Installing MegaRAID Storage Manager Software for Linux
Follow these steps if you need to install MegaRAID Storage Manager
software on a system running Red Hat Linux or SUSE Linux:
1. Copy the MSM_linux_installer...tar.gz file to a temporary
folder.
2. Untar the MSM_linux_installer...tar.gz file using the
following command:
tar -zxvf MSM_linux_installer...tar.gz
A new disk directory is created.
3. Go to the new disk directory.
4. In the disk directory, find and read the readme.txt file.
5. To start the installation, enter the following command:
./install.sh
If you select Client installation for a PC used to monitor servers, and if
there are no available servers with a registered framework on the local
subnet (that is, servers with a complete installation of MegaRAID Storage
Manager software), you cannot connect to a remote server unless you
first edit the startupui.sh file. Specifically, you must add the IP address
of the remote server to the end of the startupui.sh file.
For example, to connect to a remote framework on server 192.168.0.10,
add the IP address to startupui.sh as shown in this example:
start JRE\bin\javaw -classpath .;GUI.jar GUI.VivaldiStartupDialog
ajsgyqkj=71244 192.168.0.10