MSI X2-109 v1 - Manual (Page 58)

4-6 MegaCLI Command Tool
Version 2.0 Copyright © 2006 by LSI Logic Corporation. All rights reserved.
4.4.3 Set Adapter Properties
This command sets the properties on the selected adapter(s). For
example, for {RebuildRate -val}, you can enter a value between 0
percent and 100 percent. (The rebuild rate is the percentage of the
compute cycles dedicated to rebuilding failed drives.) At 0 percent, the
rebuild is done only if the system is not doing anything else. At 100
percent, the rebuild has a higher priority than any other system activity.
The default rebuild rate of 30 percent is recommended.
Use the command in Table 4.4 to display or set adapter properties.
4.4.4 Display Specified Adapter Properties
Use the command in Table 4.5 to display specified properties on the
selected adapter(s).
Table 4.4 Set Adapter Properties
Syntax CmdTool –AdpSetProp {RebuildRate -val} | {BgiRate –val}|{CCRate –val}|
{CoercionMode –val} -aN|-a0,1,2| -aALL
Description Sets the properties on the selected adapter(s). The possible settings are:
• RebuildRate: Rebuild rate. Values: 0 to 100.
• BgiRate: Background initilization rate. Values: 0 to 100.
• CCRate: Consistency check rate. Values: 0 to 100.
• CoercionMode: Drive capacity Coercion mode. Values: 0 = None; 1 = 128 Mbytes;
2 = 1 Gbyte. You can set the Coercion mode only when there is no existing
configuration on the adapter.
Table 4.5 Display Specified Adapter Properties
Syntax CmdTool –AdpGetProp RebuildRate | BgiRate | CCRate | CoercionMode
-aN|-a0,1,2|-aALL
Description Displays the properties of the selected adapter(s).