Chapter 2 driver installation, 1 windows 2000/2003/xp driver installation, Chapter 2, driver installation – MSI X2-109 v1 User Manual
Page 27: Windows 2000/2003/xp driver installation
Embedded MegaRAID Software User’s Guide
2-1
Version 2.0
Copyright © 2006 by LSI Logic Corporation. All rights reserved.
Chapter 2
Driver Installation
This chapter explains how to install the Embedded MegaRAID Software
drivers for the Windows 2000, Windows 2003, Windows XP, Red Hat
Linux, and SuSE Linux operating systems.
Note:
No driver installation is required for DOS. The ROM BIOS
contains the low-level driver that is required for MS-DOS.
The chapter contains the following sections:
•
Section 2.1, “Windows 2000/2003/XP Driver Installation”
•
Section 2.2, “Linux Driver Installation”
2.1
Windows 2000/2003/XP Driver Installation
Perform the following steps to install the Embedded MegaRAID Software
driver for Windows 2000, Windows 2003, or Windows XP.
1.
Boot the system with the Windows Boot Installation CD or diskette.
The following message appears:
Setup is inspecting your computers hardware
configuration.
2.
When the next prompt appears, press F6 to install the RAID/SCSI
adapter driver.
3.
When installation prompts for a key after copying some files, press
S to add the SATA RAID driver.
You are prompted for the floppy diskette that contains the LSI
Embedded MegaRAID Software driver.
4.
Insert the Embedded MegaRAID Software driver diskette and press
Enter.