MSI X2-109 v1 - Manual (Page 91)

Embedded MegaRAID Software User’s Guide 7-1
Version 2.0 Copyright © 2006 by LSI Logic Corporation. All rights reserved.
Chapter 7
Configuration
You use MegaRAID Storage Manager software to create and modify
storage configurations. RAID 0, RAID 1, RAID 5, and RAID 10 storage
configurations are supported.
Important: LSI recommends that you do not use both SAS and SATA
drives in the same array. Using different drive interfaces in
this way could cause unpredictable behavior, decreased
performance, an increased error count, and decreased
MTBF.
Note: You cannot create or modify a storage configuration unless
you are logged on to a server with administrator privileges.
This chapter explains how to use MegaRAID Storage Manager software
to perform the following configuration tasks:
•
Section 7.1, “Creating a New Storage Configuration”
•
Section 7.2, “Adding Hotspare Disks”
•
Section 7.3, “Changing Adjustable Task Rates”
•
Section 7.4, “Changing Virtual Disk Properties”
•
Section 7.5, “Deleting a Virtual Disk”
•
Section 7.6, “Saving a Storage Configuration to Disk”
•
Section 7.7, “Clearing a Storage Configuration from a Controller”
•
Section 7.8, “Adding a Saved Storage Configuration”