MSI X2-109 v1 - Manual (Page 56)

4-4 MegaCLI Command Tool
Version 2.0 Copyright © 2006 by LSI Logic Corporation. All rights reserved.
You can specify the -Silent command line option for all possible
functions of the MegaCLI CT. If you enter this option at the command
line, no messages are displayed on the screen.
Some MegaCLI CT commands that are supported in hardware RAID
configurations are not supported under Embedded MegaRAID Software.
These include the following:
•
Adapter Cache Flush (-AdpCacheFlush)
•
Set Adapter Properties: Only the RebuildRate, BgiRate, CCRate,
and CoercionMode properties are supported
•
Get Adapter Properties: Only the RebuildRate, BgiRate, CCRate,
and CoercionMode properties are supported
•
Cluster Enable is not supported
•
Set Adapter Time (-AdpSetTime)
•
Patrol Read (-AdpPR, -AdpPRSetDelay)
•
Battery Backup commands (-AdpBbuCmd)
•
Foreign configuration (-CfgForeign)
•
Logical Drive Reconstruction (-LDRecon)
•
Set Logical Drive Properties (-LDSetProp)
•
Display Enclosure Information (-EncInfo)
•
Mark Configured Physical Disk Drive as Missing (-PDMarkMissing)
•
Display List of Missing Physical Disk Drives (-PDGetMissing)
•
Flashing the firmware (-AdpFWFlash, -AdpM0Flash)
•
Diagnostics (-AdpDiag, -AdpBatTest, -AdpNVRAM)
The following sections describe the MegaCLI CT commands.
Note: The Embedded MegaRAID Software utility does not
support Write Policy, Read Policy, or I/O Policy. Software
RAID only support enabling and disabling the hard disk
drive’s write cache and read-ahead functions.
Note: MegaCLI CT for Embedded MegaRAID Software does not
support the concept of disk enclosures, except for a default
Enclosure 0 (E0). Some of the commands support an