MSI X2-109 v1 - Manual (Page 28)

2-2 Driver Installation
Version 2.0 Copyright © 2006 by LSI Logic Corporation. All rights reserved.
5. Scroll down the list and select the appropriate driver for the Windows
version installed on your system, then click OK.
6. Continue with the normal installation procedure.
2.1.1 Updating the Windows 2000/2003/XP Driver
Perform the following steps to update the Embedded MegaRAID
Software driver for Windows 2000/2003/XP or to install this driver on an
existing system booted from a standard IDE drive.
1. Click Start, point to Settings, and then click Control Panel.
2. Double-click System, click the Hardware tab, and then click Device
Manager.
Device Manager starts.
3. In Device Manager, double-click SCSI and RAID Controllers, right-
click the device for which you are installing the driver, and then click
Properties.
4. On the Driver tab, click Update Driver to open the Update Device
Driver wizard, and then follow the wizard instructions to update the
driver.
2.1.2 Confirming the Windows 2000/2003/XP Driver Installation
Perform the following steps to confirm that the Embedded MegaRAID
Software driver for Windows 2000/2003/XP is installed properly.
1. Click Start, point to Settings, and then click Control Panel.
2. Double-click System, click the Hardware tab, and then click Device
Manager.
Device Manager starts.
3. In Device Manager, double-click SCSI and RAID Controllers, right-
click the device for which you are installing the driver, and then click
Properties.
4. On the Driver tab, click Driver Details and verify that the driver
information is correct.