MSI X2-109 v1 - Manual (Page 49)

Viewing and Changing Device Properties 3-15
Version 2.0 Copyright © 2006 by LSI Logic Corporation. All rights reserved.
3.7.1 Viewing and Changing Adapter Properties
To view or change adapter properties, follow these steps:
1. On the Management Menu, select Objects
→ Adapter.
2. Select an adapter from the list. The following list of adapter
properties appears:
3. If you want to change the value of a property, highlight it and press
Enter.
4. Select or type a different value for the property and press Enter.
5. When you are finished, press Esc until you return to the
Management Menu.
Property Options Default
Rebuild Rate 0 to 100 (% of system resources) 30
Chk Const Rate 0 to 100 (% of system resources) 30
FGI Rate (Foreground
initialization rate) 0 to 100 (% of system resources) 30
BGI Rate (Background
initialization rate) 0 to 100 (% of system resources) 30
Disk WC (Disk Write
Cache) Off, On Off (Write
Through
enabled)
Read Ahead On, Off On
BIOS State Enable, Disable Enable
Stop On Error No, Yes No
Fast Init Enable, Disable Enable
Auto Rebuild On, Off On
Auto Resume Enable, Disable
When Enabled, you can stop a
consistency check, rebuild, or
initialization and resume it later where it
left off, instead of aborting it and starting
over. Enable
Disk Coercion 1
1. The Disk Coercion property can be accessed only when no configuration is
present for the adapter. Otherwise, an error message will appear.
None, 128MB, 1GB 1GB