MSI X2-109 v1 - Manual (Page 48)

3-14 MegaRAID BIOS Configuration Utility
Version 2.0 Copyright © 2006 by LSI Logic Corporation. All rights reserved.
4. Press F10.
5. At the prompt, select Yes to start the Check Consistency process
and press Enter. A graph shows the progress of the Check
Consistency operation until it is complete.
If the MegaRAID BIOS CU finds any data inconsistencies while
comparing the source and target drives, it fixes the inconsistency by
writing the source data to the target drive. When this happens, the
following message appears at the bottom of the screen:
The Data on the Drives is inconsistent. Repair done!
If the MegaRAID BIOS CU finds a media error on the source drive,
it pops up a dialog box with this message:
Error in Reading Sectors! Proceed Anyway (Y/N)?
If you press Y, the program skips the bad block and continues. If you
press N, the program aborts the consistency check. The same
message appears if the program finds a hard media error on the
target drive.
If you press Esc while a Check Consistency is running, the following
options are displayed:
•
Stop: (Available only if AutoResume is enabled on the adapter:
Management Menu
→ Objects→ Adapter→ AutoResume.) The
Check Consistency is stopped, and the CU stores the percentage of
the task already completed. If AutoResume is enabled, the Check
Consistency resumes where it left off when you restart it, instead of
starting over from 0 percent.
•
Continue: The Check Consistency continues normally.
•
Abort: The Check Consistency is completely aborted. If you restart
it, it begins at 0 percent.
3.7 Viewing and Changing Device Properties
The MegaRAID BIOS CU allows you to view properties for adapters,
logical drives, and physical drives. You can also change some properties
for adapters and logical drives.