MSI X2-109 v1 - Manual (Page 69)

Physical Drive Commands 4-17
Version 2.0 Copyright © 2006 by LSI Logic Corporation. All rights reserved.
4.8.7 Display Number of Logical Drives
Use the command in Table 4.26 to display the number of logical drives
attached to the adapter.
4.9 Physical Drive Commands
You can use the commands in this section to select settings for the
physical disk drives and perform actions on them.
4.9.1 Display Physical Disk Drive Information
Use the command in Table 4.27 to display information about the physical
disk drives on the selected adapter(s).
4.9.2 Set Physical Disk Drive State to Online
Use the command in Table 4.28 to set the state of a physical disk drive
to Online. In an online state, the physical drive is working normally and
is a part of a configured logical drive.
Table 4.26 Display Number of Logical Drives
Syntax CmdTool –LDGetNum –aN|-a0,1,2|-aALL
Description Displays the number of logical drives attached to the adapter. The return value is the
number of logical drives.
Table 4.27 Display Physical Disk Drive Information
Syntax CmdTool –PDInfo -aN|-a0,1,2|-aALL -PhysDrv[E0:Sn....]
Description Provides information about the physical disk drives connected to the enclosure and
adapter slot. The information includes the drive type, drive size, serial number, and
firmware version. For SAS devices, this includes additional information such as the
SAS address of the drive.
Table 4.28 Set Physical Disk Drive State to Online
Syntax CmdTool –PDOnline -PhysDrv[E0:Sn....] -aN|-a0,1,2|-aALL
Description Changes the physical disk drive state to Online.