Toshiba Magnia 3310 User Manual
Page 133
Advertising
Installing and Removing Hardware
SCSI device
115
1 Shut down and turn off your server.
2 Unplug all the power cables of the server.
3 Remove the server panels.
See “Removing and replacing the server panels” on page 25.
NOTE: For only the removal of a device bay spacer, it is not
necessary to remove the server panels. For installing a 5.25-
inch device instead of the device bay spacer, however, be
sure to carry out this procedure. This section describes on
the assumption that the 5.25-inch device is replaced.
4 Pull the device bay spacer out of the slot while pushing the
hooks on both sides.
Pulling the device bay spacer out of the slot
NOTE: The rails installed in the device bay spacer should be
used when installing a SCSI device in the device bay.
Advertising