Toshiba Magnia 3310 User Manual

Page 158

Advertising
background image

Installing and Removing Hardware
Expansion cards

140

When using AF200C, you must connect the SCSI cable
to the channel 0 side among two SCSI connectors.
See “RAID Controller's User’s Guide.”

11 If expansion cards have been removed, install them according

to the procedure.
See the steps 4 and 5 in “Installing the expansion card” on page
132.

12 Attach the intake fan unit and fix it with a screw.

13 Connect the cable of intake fan unit to the extension cables

connected to the motherboard.

Connect the standard intake fan module to the extension cable
connected to the FAN2 connector on the motherboard.

Connect the redundant intake fan module to the extension
cable connected to the FAN2-R connector on the motherboard.

14 Fit the panels to the server.

See “Removing and replacing the server panels” on page 25.

15 Connect all the power cables of the server to the power supply,

and switch on the server.
To set up the disk array (RAID) and install the software:
See “RAID Controller’s User’s Guide“

NOTE: After removing an expansion slot panel, store it in a
safe place.

Advertising