Toshiba Magnia 3310 - Manual (Page 186)

System Configuration Setup
Onboard SCSI utility 168
Boot Device Configuration
Set the SCSI devices to be booted by the system.
When you select this menu, the following submenu appears.
Master SCSI Controller : AIC-7902 X at slot XX
XX:XX:XX
Set the onboard SCSI controller connected to the device to
be booted by the system.
Do not change the setting value.
SCSI Device Configuration
Set the system configuration information details of each SCSI
device (SCSI ID).
When you select this menu, the following submenu appears.
Sync Transfer Rate (MB/Sec): 320
Set the maximum sync transfer rate of the onboard SCSI
controller.
Packetizes:Yes
Set whether to use packet format for command protocols.
QAS:Yes
Set whether to make device selection speedy.
Initiate Wide Negotiation: Yes
Select Yes to set wide SCSI (16-bit data width).
Enable Disconnection: Yes
Select Yes to enable the adapter disconnect/reconnect func-
tion and enable composite command generation.
Send Start Unit Command: Yes
Set whether or not the start unit command is sent from the
onboard SCSI controller and SCSI devices are started up.
BIOS Multiple LUN Support: No
Set whether or not to support logical unit numbers.