Toshiba Magnia 3310 - Manual (Page 192)

Installing Software
Windows Server® 2003
175
3 Insert the Windows Server 2003 driver floppy disk of RAID
controller, which comes with your RAID controller, in the
floppy disk drive, and then press the <Enter> key.
4 When the list of drivers appears, select the driver for each
RAID Controller, according to the following procedure.
5 For RAID Controller MR520, select “MegaRAID SCSI 320-1
RAID Controller Driver” and then press the <Enter> key.
6 For RAID controller MR518, select “MegaRAID SCSI 320-2
RAID Controller Driver”, and then press the <Enter> key.
After this, continue to install Windows Server 2003, following
the instructions that appears on the screen.
NOTE: When using RAID Controller, be sure to install the
RAID Controller Utility after installation of the Windows
Server 2003.
RAID controller utilities: Install Power Console Plus for RAID
controller MR518/MR520.
See “RAID Controller's User’s Guide.”
Selecting a driver for the onboard SCSI controller
To select the driver, follow these steps.
1 When the Windows Server 2003 Setup screen appears and
"Press F6..." is displayed in the lower left hand corner of the
screen, press the F6 key.
2 When a message appears on the screen, asking whether you
want to add a device driver for mass storage device, press the
<S> key.
3 Insert the “Adaptec SCSI Windows Server 2003 Driver”
floppy disk, which was created previously with the Toshiba
MegaRAID SCSI 320-1 RAID Controller Driver
MegaRAID SCSI 320-2 RAID Controller Driver