Toshiba Magnia 3310 - Manual (Page 200)

Installing Software
Windows® 2000 Server
183
NOTE: When using RAID Controller, be sure to install the
RAID Controller Utility after installation of the Windows 2000.
RAID controller utilities: Install Power Console Plus for RAID
controller MR518/MR520.
See “RAID Controller's User’s Guide.”
Selecting a driver for the onboard SCSI controller
To select the driver, follow these steps.
1 When the Windows 2000 Server Setup screen appears and
"Press F6..." is displayed in the lower left hand corner of the
screen, press the F6 key.
2 When a message appears on the screen, asking whether you
want to add a device driver for mass storage device, press the
<S> key.
3 Insert the “Adaptec SCSI Windows 2000 Driver” floppy disk,
which was created previously with the Server Setup TooL,
onto the floppy disk drive, and then press the <Enter> key.
4 When the following message appears, select “Adaptec
Ultra320 SCSI Cards (Win2000)” and then press the <Enter>
key.
If there are no other SCSI drivers to be added, then continue to
install Windows 2000, following the instructions that appear
on the screen.
Adaptec Ultra320 SCSI Cards (Win2000)