Toshiba Magnia 3310 - Manual (Page 171)

System Configuration Setup
BIOS setup utility
153
Advanced menu
All are recommended settings (defaults).
™ I/O Device Configuration
When you select this, the following submenu appears.
Serial port A : Enabled
Make the setting of the serial port 1.
™ BASE I/O address
Set the I/O port address of serial port 1.
Serial port B : Enabled
Make the setting of the serial port 2.
™ BASE I/O address
Set the I/O port address of serial port 2.
Parallel port : Enabled
™ Mode : ECP
Set the operation mode for the parallel port; select “ECP.”
I/O Device Configuration
On Board Device
Installed O/S [Win2000/.NET]
Boot-time Diagnostic Screen [Enabled]
Reset Configuration Data [No]
Large Disk Access Mode [DOS]
PS/2 Mouse [Enabled]
Summary screen [Disabled]
Legacy USB Support [Disabled]
PXE of NIC1 Support [Disabled]
PXE of NIC2 Support [Disabled]
Hyper-Threading [Enabled]
Memory Remapping [Enabled]
After AC Power Loss [Last State]
Wake-On-LAN [Disabled]
Terminate PEF Action [Disabled]
Post Error Halt [Enabled]
FRB2 Policy [Enabled]