Toshiba Magnia 3310 User Manual
Page 41
Getting Started
Rear view
22
(5) Parallel connector (
)
Used to connect a printer.
(6) RGB connector (
)
Used to connect a display device.
(7) Ether1 connector (
)
Used to connect a 1000BASE-T, 100BASE-TX or 10BASE-T
Ethernet LAN.
(8) Ether2 connector (
)
Used to connect a 100BASE-TX or 10BASE-T Ethernet LAN.
(9) USB1 connector (
)
Used to connect USB (Universal Serial Bus) devices.
When connecting a USB device, ensure that the operating sys-
tem installed supports USB1.1.
(10) USB2 connector (
)
Used to connect USB (Universal Serial Bus) devices.
When connecting a USB device, ensure that the operating sys-
tem installed supports USB1.1.
(11) Ether1 indicator (ACT)
Indicates the communication status of Ether1.
Flashing green ... Data being transferred
Off ... No traffic/connection error
(12) Ether1 indicator (LNK)
Indicates the communication status of Ether1.
Lit yellow...Connected successfully
Off...Not operating/operation error
(13) Ether2 indicator (ACT)
Indicates the communication status of Ether2.
Flashing green ... Data being transferred
Off ... No traffic/connection error
(14) Ether2 indicator (LNK)
Indicates the communication status of Ether2.
Lit green ...Connected successfully
Off...Not operating/operation error
See “Connecting peripheral devices” on page 37.
Ether
Ether