Toshiba Magnia 3310 - Manual (Page 81)

Installing and Removing Hardware
Installing and removing optional devices
63
NOTE: Before sliding the server out of the rack, make certain
that no cable connected to its back disturbs the sliding job.
To continue the installing/removing job as the server is slid
out of the rack, slide the server frontward until it is secured by
the lock on the rail.
If another system or an extension disk unit is installed in the
rack besides the server, be careful not to touch the eject lever
of the hard disk drive mounted in another system or the
power botton.
Sliding the server (rack model) out of the rack
See “MAGNIA Series Rack Mount/Install Guide” on this CD
1 If there is an external device connected with the server, check
the length of the cable whether it is enough for sliding.
If the cable is too short to slide the server, disconnect it before-
hand to avoid unexpected disconnecting during sliding.
2 Loosen the 2 screws on both sides and release the lock.
Releasing the lock (rack model)