JLG X14J Operator Manual User Manual
Page 106
7.4 G
REASING THE TELESCOPIC ARM
Use a brush to apply grease onto the telescopic exten‑
sion arms.
7.5 S
AFETY INSTRUCTIONS FOR MAINTENANCE OPERATIONS
•
Spare parts must correspond to the technical provisions established by the Constructor.
This is guaranteed by the use of original spare parts.
•
Errors can be extremely dangerous. Before greasing or making repairs read the user and
operation manual carefully.
•
Handle all parts with special care. Keep hands and fingers away from concealed spaces,
gearing and similar. Always use approved safety devices, such as goggles, gloves and
safety footwear.
•
When working on the electrical system always wear protective goggles and remove
rings, watches and any other metal jewellery. As a general rule, do not use petrol to
clean parts.
•
Work on the auxiliary electrical system must only be performed by our service depart‑
ment so as to guarantee conformity with the requirements of the standards in force (EN
60204 and national standards).
•
Always disconnect the batteries before working on the electrical system.
•
Hydraulic hoses must be correctly laid and fitted.
•
Tampering with the hydraulic circuit may cause serious danger during use of the
platform.
•
Do not dispose of lubricants in the environment but rather collect and dispose of them in
compliance with laws in force in the country in question.
•
Check the vehicle at least once per day or shift for any external damage (corrosion,
structural parts, welds). The person in charge must be informed immediately of any
change observed (including functional behaviour). In this case, stop the vehicle imme‑
diately and carry out more detailed checks.
X14JR0420113
102
BOOM LIFT MODELS X14J
JLG