JLG X14J Operator Manual - Manual (Page 81)

6.4.10 A
UTOMATIC LOWERING AND RAISING OF THE STABILISERS
JLG elevating platform is fitted with an innovative automatic levelling procedure that acts on
the stabilisers and uses the electronic spirit level provided on the main control board.
For the self‑levelling procedure, all the precautions described to this point apply.
Before starting the self‑stabilization make sure that the machine is on a slope less than the
total admitted limit for stabilization (see technical date of the machine) and verify that the
trajectory of the stabilizers is free of obstacles and impediments.
The automatic procedure for levelling the machine extends and retracts the stabilisers,
and consequently moves the machine. Always check that there are no people, animals or
things in the stabilisation area.
• AUTOMATIC LOWERING OF THE STABILISERS
Press and hold button 7 on the radio control.
The success of the self‑levelling procedure is confirmed by an icon displayed on the screen
for several seconds.
After the end of the procedure, always control that the spirit level is in the green zone. If this
does not occur contact JLG after sales service.
If during the lowering phases one or more stabilisers stop before touching the ground,
immediately release the botton and after some seconds press again. Repete this operation till
ATTENZIONE
X14JR0420113
BOOM LIFT MODELS X14J
JLG
77
OK
ATTENTION