JLG X14J Operator Manual - Manual (Page 145)

141
9 SERVICE MENU ON THE REMOTE CONTROL
A SERVICE button is available on the remote control (ref. button 6), used to display the sta‑
tus of the machine parameters and as assisting device for the safety checks to be carried out
on the machine, as specified in this manual.
Pressing button 6 accesses a numerical menu, controlled by the number buttons on the remo‑
te control. The meaning of these menus is explained in this manual. If after reading the
manual you still have some doubts, contact the JLG after‑sales service.
1 INPUT
2 LANGUAGE
3 ERRORS
4 RAMPS
5 CURRENT
6 OP. HOURS
7 SETTINGS
8 JOYSTICK
9 EXIT
M
ENUS 4 AND 5 ARE NOT ACCESSIBLE
9.1 I NPUT MENU
This displays the signals received by the board from the various sensors fitted on the machi‑
ne and from the controls on the remote control. Each screen shows the status of the input
and options to scroll the menu:
1 PREC access the previous input
2 SUCC access the next input
9 ESCI exit the INPUT menu
BOOM LIFT MODELS X14J
JLG
X14JR0420113
ST TERR 1A
If both are ON, stabiliser 1 is resting on the ground. ST TERR 1B
ST TERR 2A
If both are ON, stabiliser 2 is resting on the ground. ST TERR 2B
ST TERR 3A
If both are ON, stabiliser 3 is resting on the ground. ST TERR 3B
ST TERR 4A
If both are ON, stabiliser 4 is resting on the ground. ST TERR 4B
ST APERT1A
If both are ON, stabiliser 1 is completely open TOTAL AREA. ST APERT1B
ST APERT2A
If both are ON, stabiliser 2 is completely open TOTAL AREA. ST APERT2B
ST APERT3A
If both are ON, stabiliser 3 is completely open TOTAL AREA. ST APERT3B
ST APERT4A
If both are ON, stabiliser 4 is completely open TOTAL AREA. ST APERT4B