JLG X14J Operator Manual - Manual (Page 84)

PROCEDURE FOR ROUTINE MOVEMENT OF THE AERIAL PART
• Before moving the aerial part, make sure that:
‑ all instructions provided in this chapter have been complied with;
‑ there are no obstacles in the work area;
‑ all the conditions necessary for working at a height are met:
the machine is stabilised and levelled: icon 5 shown on the display,
the weight in the basket is below the maximum allowed,
the remote control is positioned in the basket.
‑ The basket access ladder has been folded into the raised position so as not to risk con‑
tact during movement of the aerial part.
• The aerial part can ONLY be moved from the control position in the basket.
• Select the motor speed as required and check the selection on the display.
• Use the Joysticks 2, 3, 4, 6, 7 to move the aerial part of the machine according to the
instructions gien in the paragraph describing the controls.
The use of the jib arm is only allowed if the working load is less than or equal to 120 kg.
• If the movements are selected when one of the conditions listed above is not satisfied, an
error message will be shown on the display indicating what conditions are OK and what
are not satisfied. If the missing condition is stabilisation, the message will also indicate
what stabiliser is not resting on the ground.
ST1: if OK stabiliser 1 is resting on the ground
ST2: if OK stabiliser 2 is resting on the ground
ST3: if OK stabiliser 3 is resting on the ground
ST4: if OK stabiliser 4 is resting on the ground
INLC
: if OK the machine is under the maximum inclination limit
LOAD : if OK, the load is less than the maximum working load allowed
CESTO: if OK, the remote control is in place in the basket
PEDAL
: if OK the footswitch is pushed
ATTENZIONE
X14JR0420113 80
BOOM LIFT MODELS X14J
JLG
ATTENTION