JLG X14J Operator Manual - Manual (Page 99)

95
The battery charger supplied with the X14J elevating platform was designed to ensure safety
and reliable performance. It is already fitted on the machine and does not need any adjust‑
ment or configuration by the user; nonetheless, to avoid injury and damage to the battery
charger, the following essential precautions should be observed:
• Carefully read the installation instructions contained in this manual. For future reference,
keep the manual in a safe place.
• Do not place the battery charger near sources of heat.
• As the battery charger is sealed and without forced ventilation, its performance depends
on the temperature and the type of installation.
• Make sure that the type of power supply available corresponds to the voltage specified
and indicated on the battery charger rating plate or in this user and operation manual. In
case of doubt, contact your reseller or the local electrical company.
• An AC class circuit breaker can be used as protection device for the battery charger
power supply, however it is recommended to use a classA or class B device..
• With regards to safety and electromagnetic compatibility, the battery charger features a
three‑pin plug with earth, which can only be plugged into an earthed socket. If the plug
does not go into the socket, most probably the socket is old and not earthed. In this case,
contact an electrician to have the socket replaced.
• Do not use adapters to resolve earth plug problems.
• Make sure the power cable does not represent an obstacle. If the cable is worn or dama‑
ged, have it replaced immediately.
• If extensions or multiple sockets are used, make sure that these support the total rated
current.
• Disconnect the power supply before connecting or disconnecting the battery.
• The battery charger installed was specially designed to recharge the type of lithium batte‑
ries used on the platform. Do not attempt to recharge any other type of batteries.
• Do not attempt to repair the battery charger. Opening the cover may expose the user to
the risk of electric shock.
• Do not open the battery charger, opening it may affect the index of protection (IP) even
after it has been closed again.
• If the battery charger is not working correctly or is damaged, disconnect it immediately
from the power outlet and the battery socket and contact the an authorized servicing
entity.
Charge curve
The battery charger features just one charge curve (IUIa) plus balancing and maintenance,
designed specially for recharging the battery pack of the JLG self‑propelled elevating
platform.
BOOM LIFT MODELS X14J
JLG
X14JR0420113
ATTENZIONE
WARNING