JLG X14J Operator Manual - Manual (Page 71)

6.4.2 S TARTING THE PETROL / DIESEL ENGINE
Before starting the engine it is necessary to:
‑ Become familiar with all the procedures described in the USER AND OPERATION
MANUAL of the machine and of the engine, and to know the meaning of the safety
labels.
‑ Examine the safety rule summary table in the manual and follow all the instructions
given therein.
‑ Make sure that the fuel cap is properly tightened.
‑ Make sure that there are no residues of petrol or flammable materials near the exhaust
silencer or other areas subject to overheating.
‑ Make sure that no one is standing near the machine.
‑ Make sure that all the emergency STOP buttons are released; this condition can be
checked on the radio control display, where no icon should appear in position 7.
If the operator attempts to start the machine with the emergency stop button still pres‑
sed, an error message will appear on the display when the start button is pressed.
‑ The engine can be started from the ground using the start key, or directly by means of
the remote control. In this case it is necessary to move the engine start key in position
ON before getting on the basket using the handrails to reach the control position. At this
point, use the button on the remote control to start the engine.
‑ The petrol engine starter is automatic.
‑ If the operator attempts to start one of the two motors while the other is already run‑
ning, starting will be impossible and the icon showing the motor already on will appear
at the centre of the screen.
X14JR0420113
BOOM LIFT MODELS X14J
JLG
67