JLG X14J Operator Manual - Manual (Page 155)

151
BOOM LIFT MODELS X14J
JLG
X14JR0420113
CODE DESCRIPTION STATUS ACTION
248
Temperature inside
battery charger too
high.
If internal temperature exceeds
80°C, battery charger reduces
power to 80%, while it stops
operating altogether if internal
temperature exceeds 90°C. Bat‑
tery charger starts at full
power again when internal
temperature falls below 70°C.
249
Battery temperature
too high.
If temperature exceeds 55°C or
is less than ‑20°C, battery char‑
ger stops working.
When battery temperature falls
below 45°C or exceeds ‑10°C
battery charger resumes nor‑
mal operation.
251
Power failure
detected.
Battery charger stops sup‑
plying power. Operation resu‑
mes as soon as alarm condi‑
tions are no longer present.
If problem persists, check
battery charger mains
power supply.
242
Error when reading
internal memory on
microcontroller.
Battery charger stops working.
Contact service dept. or
change product.
18
Extended shutdown
or power failure.
Battery charger stops sup‑
plying power. Operation resu‑
mes as soon as alarm condi‑
tions are no longer present or
after restarting.
If problem is a power failu‑
re, check battery charger
mains power supply.
245
Abnormal current
draw in primary sec‑
tion.
Battery charger stops sup‑
plying power. Operation resu‑
mes as soon as alarm condi‑
tions are no longer present.
If problem persists, contact
service dept. or change
product.
240
Digital input is open
and managed as
hardware start‑stop.
Battery charger stops charging
until digital input closes.
Close digital input.