2N PRI Gateways - User Manual - Manual (Page 13)

!! Preliminary version of user guide v1.8 !!
!! Preliminary version of user guide v1.8 !!
11
No SW is necessary for configuration – system communicates through an RS232 interface
and Telnet protocol using standard extended AT commands. However, high-quality software
running under the Windows OS has been designed for user-friendly control and configuration.
Fault diagnostics is very simple too – system informs of a fault both visually (by LED
diodes) and via any interface. A direct display of all processes on ISDN or IP layers is a matter
of course too.
Quality control – you can check the quality of system calls any time by test calls (an
analog headset connector is available for test calling into GSM networks or ISDN interface) or
by-hearing of one of the two current call directions.
Quick and easy update – since PRIGW is not bound to any operating system, any
firmware updating is quick and comfortable and is made by the available software. Updating can
be performed locally or remotely and the process is protected against unintentional
disconnection. The updating process takes a few minutes and the existing configuration is
retained.
** optional part
*** actually not possible, but it will be possible to replace 1. GSM card by 1x PRI card.