2N PRI Gateways - User Manual - Manual (Page 59)

!! Preliminary version of user guide v1.8 !!
!! Preliminary version of user guide v1.8 !!
57
• GSM Monitor info – With using this feature you can download information GSM cell where
is GSM module connected.
Description of response parameters from TC35i module:.
Chann ARFCN (Absolute Frequency Channel Number) of the BCCH(THC)
carrier. If chann is h BTS supports hopping during a connection
Rs RSSI (Received signal strength) of the BCCH carrier from 0 to 63. The
indicated value is composed of the measured value in dBm plus an
offset. This is in accordance with a formula specified in 3GPP TS05.08
dBm Receiving level of the BCCH carrier in dBm
PLMN PLMN ID code
LAC Location area code (HEX)
Cell Cell ID code (HEX)
NCC PLMN color mode
BCC Base station color mode
PWR Maximal power level used on RACH channel in dBm or current power
level
RXLev Minimal receiving level (in dBm) to allow registration
C1 Coecifient for base station selection
TS Timeslot number
timAdv Timing advance in bits
Q Receiving quality (0-7)
Chmod Channel mode (S_HR: Half rate, S_FR: full rate, S_EFR: Enhanced full
rate)
• Export statistics – used for storing and clearing of statistic data from the PRIGW
connected. For a detailed description of statistic data refer on page 97.
• Data into gateway – sends and saves the configuration file into the gateway, the program
then resets the gateway – for internal configuration updating – and saves the config.cfg file
into the PRIGW program folder (or a folder pre-defined by you if you use the "Multi-gateway
menu“ options).
• Reset – resets the gateway and initializes all PRIGW boards (the gateway communication
is not discontinued but all current calls and SMS to be sent are terminated!).
• Factory reset – resets the gateway, selecting the factory settings for the PRIGW . The
gateway communication is not discontinued upon this command.
• Firmware / Licence – uploads the firmware into the gateway.