2N PRI Gateways - User Manual - Manual (Page 65)

!! Preliminary version of user guide v1.8 !!
!! Preliminary version of user guide v1.8 !!
63
9.7.3.1
System parameters
This window allows you to set the basic parameters of your PRIGW .
-
IP address : IP address of the PRIGW’s CPU card Ethernet port
-
Subnet mask : IP mask of IP address
-
IP router : IP address of network gateway of your Ethernet network
- Init sequence for modem : an AT command sent by the PRIGW via COM2 when it detects
a connected modem.
- Saving call data (CDR) : Type of CDR which gateway will save.
- No calls – the gateway does not record any call information.
- Successful outgoing – gateway records information of all successfully connected
outgoing calls
- Successful outgoing+incoming – gateway records information of all successfully
connected outgoing+incoming calls.
- All outgoing – the gateway records information on all outgoing calls.
- All outgoing+incoming – the gateway records information on all outgoing and
incoming calls.
-
PIN : the PIN code that the gateway tries to enter if a SIM card with active PIN is inserted
(this item has no meaning if a SIM card without active PIN is used).
-
Gate ID : the number which will be added to call data records line. With this number you can
more easy detect on which PRIGW were CDR generated (in case that you collecting CDR
from more than one PRIGW gateways)
- General selection of SIM cards : selection of SIM card after start/restart of PRIGW
- According to GSM groups –SIM card will be selected by GSM group settings.
- SIM cards in slot X – after start/restart will be chosen SIM card in holder X (In case
that setting in GSM group is different, SIM will be automatically switched according to
GSM group settings)