2N PRI Gateways - User Manual - Manual (Page 87)

!! Preliminary version of user guide v1.8 !!
!! Preliminary version of user guide v1.8 !!
85
GSM modules
AT&Qxx Received GSM signal level (xx=00-15)
AT&QALL
Received GSM signal level from all GSM modules
AT&Gxx=atcmd Send command for AT commands directly into GSM module
AT&Gxx=at+cnum – SIM card telephone number
AT&Gxx=at+cpin=”xxxx” – PIN entering
AT&Gxx=at+clck=”sc”,1”xxxx” - PIN request enable
AT&Gxx=at+clck=”sc”,0”xxxx” - PIN request disable
Log file
AT&L
Log file listing (PRIGW awaits pressing of the Space bar after
every 20 lines)
AT&C
Call file listing (PRIGW awaits pressing of any key after every 20
lines)
AT&CR Call file listing and deleting (PRIGW awaits pressing of the key
“#“ for delete this line /with info about call/ form memory and send
next line)
11.2. Configuration Commands
11.2.1. Status Information
AT&V
Overview of all system settings
AT&VI Overview of PRI ISDN settings
AT&V0 Overview of basic GSM settings
AT&V#
Overview of #-the GSM group settings (#=1-8)
AT&VALL Overview of all GSM group settings
AT&N#
Overview of parameters of network list no. # (#=1-8)
AT&NALL Overview of parameters of all network lists
AT&R
Overview of LCR lines
11.2.2. Default Reset
AT&FRES
Reset with gateway factory settings
11.2.3. System Settings
AT%S70=x.x.x.x IP address
AT%S71=x.x.x.x
IP address mask
AT%S81= Initialization string for setting of mode connected
to the gateway COM2
AT%S90=x Type of assignment of B-channels to GSM
modules (0-rotating; 1-locked; 2-according to
credit)
AT%S91=x,y
Way of call information recording (0- no record;
1- successfully connected outgoing call; 2-
successfully connected incoming calls; 3-
successfully connected incoming and outgoing
calls; 5- all outgoing calls; 6- all incoming calls; 7-
all incoming+outgoing calls)
Y = to each call add NET info (1) or no (0)
AT%S93=x Global selection of SIM card (0= according to