2N PRI Gateways - User Manual - Manual (Page 98)

96
12.2.3. LOG File events
Type Text Description
POWER [Power on] System switched on
[Power off] System switched off
[Warm boot] Restart of system, unknown cause
[Watchdog] Restart of system by watchdog
[BKPT code] CPU error: break code detected
[Stack error] CPU error: stock integrity failure
[Divided by zero] CPU error: dividing by zero
[RETI code] CPU error: illegal using of instruction reti
[NMI intr] CPU error: wrong interrupt
[VOID intr] CPU error: wrong interrupt
[Upgrade reset] Start of upgrade firmware procedure
[Software reset] Reset by AT commands (at&fres…)
INIT Eeprom Initialization of eeprom (configuration)
Flash Initialization of flash memory (firmware)
HW-ERR (##…address of chip, RD…read value/WR…expected
value)
Codec ##,RD/WR Error in initialization of codec on GSM,AUX board
COM2 #####,RD/WR Error in initialization of COM2 on AUX board
Duart #####,RD/WR Error in initialization of serial controller on GSM board
Hscx #####,RD/WR Error in initialization od HDLC controller on AUX board
Pri #####,RD/WR Error in initialization od PRI controller
SYSERR User stack error! SW error: stock integrity failure
BRDIN #08 TYP STS the board inserted (number of gsm board, type, status)
BRDOU
T #08 TYP STS the board disconnected
BRDRES #08 TYP STS Reset the board by AT command
ALL GSM RESET CMD Reset of all GSM boards by AT command
SYSTEM RESET CMD Reset of system by command at&bsys
L1-ERR (reserved)
L2-ERR Error of 2. ISDN layer by Q.921
A: unsol.RX(F) Received packed RR,RNR,REJ with unexpected bit F=1
B: unsol.DM(F) Received packed DM with unexpected bit F=1
C: unsol.UA(F) Received packed UA with unexpected bit F=1
D: unsol.UA(-) Received packed UA with unexpected bit F=0
E: unsol.DM(-) Received packed DM with unexpected bit F=0
F: peer re-est Received packed SABME in status OKEST
G: repeated SABME Repeated unsuccessful send of packet SABME
H: repeated DM Repeated unsuccessful send of packet DM
I: failed (TIMREC) Unsuccessful breaking-up of status TIMREC
J: N(R) error Received wrong value N(R) – numbering of packets
K: recv.FRMR Received packed FRMR (information about error)
L: undef.frame Received unknown type packed
M: (I field) Received wrong I-packet (numbered packet)
N: frame size Received packed with wrong length
O: N201 error Value N201 was exceeded (max. length of packet)
L3-ERR tout sts # (p##) Error of 3. layer isdn: timeout in status # on channel p##
G2-ERR ATD/ERROR init (g##) Error of 2. layer isdn: restart of module g## after rejected
command ATD by GSM network
GSM Cause 150 (g##) Error of 2. layer isdn: restart of module g## after cause
150 was received (call barred by GSM network)
G3-ERR tout sts # (g##) Error of 3. layer isdn: timeout in status # on module g##
C4-ERR tout sts # (p##/g##) Error of 4. connecting layer: timeout in status # on call
between channel p## and GSM module g##