2N PRI Gateways - User Manual User Manual
Page 50
48
8.3.4. Prefixes to GSM
Currently not used, please do not change this table
8.3.5. Prefixes to ISDN
Currently not used, please do not change this table
8.3.6. Setting
Before you start to use Voice callback software you have to set parameter X10 in your PRI
ISDN gateway by the following way :
- open the management software (e.g. PRIGW program)
- establish connection with the gateway
(over serial interface or TCP/IP)
- in menu Gateway control open "
Terminal "
- write a command
AT%X10=60 and press enter
If you sent the right command, the gateway responses OK.
Please before using of Voice Callback Center, check at 2N web pages (
www.2n.cz/export
) the
latest version of XAPI server and Voice Callback Center software.
If you have a technical question, please contact 2N’s technical support team at