2N PRI Gateways - User Manual User Manual
Page 84
82
10.4. Set-up Accounter program
By starting Accounter program click on icon
for setting of the program. Here you have
options set in individual flags:
Starts – setting of individual times, when the program will automatically save cdr info
from PRIGW + selection of the method of
saving in the files.
− A Time : 1 time of automatic saving
− B Time : 2. time of automatic saving
− C Time : 3. time of automatic saving
− Repeatedly : Will automatically save
cdr each xx minutes (if set for 0, this
method is off)
− At start program : Automatic save of
cdr by start of the program
− Only one file : If marked, program
saves cdr info in one file
(Dddmmyy.cdr), if not marked , he
differentiate following the method of
saving (1 time – file
DddmmyyABSx.cdr, 2 time –file
DddmmyyB.cdr,3 time – file
DddmmyyCBSX.cdr, Repeatedly –
DddmmyyBSx.cdr, At start- file
DddmmyyABSx.cdr)
− Use : Activation of this flag
List – number of lines that will be represent in the status window.
Login – Log in name, password.
− Name : Log in name in the BS
− Password : Log in password in the BS
− Save pass : Saving of the log in password foe next start of the program
− Login attempts : Number of trials of the program by automatic log in.
Make sure that user’s password and name are identical with n and p which
are saved in connecting PRIGW. By invalid n or p the program will ask for
valid characteristics.
TCP/IP – Parameters for connecting of the program to the BS
− IP : IP address of connecting BS (enter in the right form ! e.g:192.168.50.2)
− Host : Network name connecting BS (available in higher versions of the
firmware - for the present time do not fill out please)
− Port : Number of the remote data port for communication via TELNET
(standard 23).
− Service : Title of the protocol – DO NOT FILL OUT !