2N PRI Gateways - User Manual - Manual (Page 22)

20
3.4. VoIP board
3.4.1. Board Description
The VoIP mainboard contains VoIP card with signaling processors and main control
processor. On mainboard are is located 10/100BaseT Ethernet switch and processor for
convertion of voice streams. The mainboard is designed on a 4-layer PCB of the size of
160x100mm. 5 board status indicators are located on the front panel.
Possible statuses of indication LED diodes (units with firmware 02.09.xx and higher):
PWR LED Indicates board supply
Lights on Switched on
Lights off Switched off
Blinking Board in sleep mode
INIT LED
Indicates board initialization or error status
Blinking Indicates the initialization of the desk
Lights on (still) Board initialization failure
Lay 2 LED
Not implemented
Lay 3 LED
Not implemented
VoIP board is configurable by web interface (see chapter VoIP board configuration).
Signalization packets (SIP) must be routed to IP address of CPU, voice stream (RTP packets)
to IP address of VoIP board !
3.5. Thin VoIP board
3.5.1. Board Description
New “thin” variant of VoIP card for StarGate*, BlueStar* and BlueTower systems. VoIP
board contains digital signaling processor, license chip. There is also located10/100BaseT
Ethernet switch.
The mainboard is designed on a 4-layer PCB of the size of 160x100mm.
5 board status indicators are located on the front panel. Configuration of this type of VoIP
board is completely via standart configuration tool.
Possible statuses of indication LED diodes (units with firmware 02.09.xx and higher):
PWR LED Indicates board supply
Lights on Switched on
Lights off Switched off
Blinking Board in sleep mode
INIT LED Indicates board initialization or error status
Blinking Indicates the initialization of the desk
Lights on (still)* Board initialization failure
Signalization packets (SIP) must be routed to IP address of CPU, voice stream (RTP packets)
to IP address of VoIP board !
*Normal initialization of the board is about 1 minute from start of whole system.