2N PRI Gateways - User Manual - Manual (Page 53)

!! Preliminary version of user guide v1.8 !!
!! Preliminary version of user guide v1.8 !!
51
9.4.1. File Menu
Using this menu, you can work with the config.cfg gateway configuration file or default
configuration file, i.e. load, save, ... Contains an item for program end too.
• Load – loads the last-saved configuration file
from the PRIGW program directory. Or
requires loading of default settings upon first
run.
• Save – saves the current settings into the file,
the PRIGW program directory (or into a
folder defined in the List of gateways – refer
to 9.4.2).
• Load from – loads a file from a folder
selected by you.
• Save as – saves a file into a folder selected
by you.
• Default settings – loads the preset default configuration.
• Program end – terminates the program.
9.4.2. Gateway Menu
Used for connecting / disconnecting the gateway. You can select a gateway from the List of
gateways if you use remote control.
• Connect gateway – connects the PRIGW with
your PC and establishes mutual communication via
an RS232 serial interface or using the Telnet
protocol.
Note: The gateway must be connected and the
"Setting > Communication" items have to be
selected properly.
• Disconnect gateway – disconnects the gateway
and discontinues its communication with your PC.
If you communicate with more gateways than one, you are advised to have each
configuration file in a different directory to avoid unintentional rewriting of the
configuration file by another gateway configuration. To do this, use the following menu: